Table of contents
| 目次 | ||||
|---|---|---|---|---|
|
1. Introduction
This document explains how to give your consent to the release of attributes to Service Provider via uApprove.jp
The user consent steps are as follows:
- Login with Username/Password authentication.
- Accept the terms of use.
- Select the optional attributes to be released to Service and confirm it.
- Final confirmation of release.
- The attributes are released to a Service.
2. Operation flow
2.1 Login
You are redirected to the IdP login page (figure 1) from Service Provider. IdP requires a pair of username and password for authorization. If authorization is succeeded, you proceed to the terms of use page or the attributes selection page.
If you want to login, enter your Username/Password and press "Continue" button.
If you want to reset attribute release approvals, you have to check the checkbox "Reset my attribute release approvals"(see uApprove.jp user 's manual).
If you want to reset when the "Reset my attribute release approvals" checkbox is not displayed, you have to access the page of the list of approved SP(see uApprove.jp user 's manual).
2.2 Terms of use
You may get the terms of use page (figure 2) after success of login. This page will be shown if:
...
2.3 Optional attribute selection
This page shows information about you that will be released to the SP, in the form of a Digital ID Card (figure 4).
...
- I always check ... (default)
- You can confirm the information that will be released to this SP, on every login session.
- I agree ...
- Allow to send the selected information when you use this SP again, automatically. If next time you use this SP, this page will not display again unless attributes have been changed (see uApprove.jp user 's manual).
- Don't show me ...
- Allow to send all attributes to any SP automatically. If you choose this, all the optional attributes will be checked and can not be unchecked. This page will never display again even if the some attributes are changed (and possibly adding the different attributes).
...
2.3.1 Review the attributes change
When any of the following conditions is satisfied on the SP where "I agree ..." option is applied, auto attributes sending is stopped and this review page (figure 6) is displayed.
...
| ギャラリー | ||||||
|---|---|---|---|---|---|---|
|
2.4 Final confirmation of release
Attributes which are going to be released to the SP are displayed on the form of Digital ID card in this page (figure 7).
You do the final confirmation before sending attributes to SP.
...
2.5 Release of information
Mandatory attributes and selected optional attributes are sent to the SP.
...
3. Reset-approvals
This page is displayed by checking "Reset my attribute release approvals" on login page (figure 9).
...
- Stop to automatically send the information to any SP
- Redirect to attributes selection page (uApprove.jp user 's manual)
- Make all checkbox for optional attributes be deselected
...
4. List-approvals
If you access to the URL of the page of the list of approved SP, and authentication on IdP is succeeded, you can browse that list.
...
If the page of final is prepared by administrator, the "Exit" button navigates to that page.
4.1 Revocation of consent
You can revoke consent by click the "Reset" or "Reset all" button.
...