ページ履歴

...

Following instruction is based on the CentOS6 installation as Minimal package.

After installing the OS, please change the SELinux setting to be Permissive or Disable.
Configuration file is located at /etc/sysconfig/selinux

# This file controls the state of SELinux on the system.
# SELINUX= can take one of these three values:
#     enforcing - SELinux security policy is enforced.
#     permissive - SELinux prints warnings instead of enforcing.
#     disabled - No SELinux policy is loaded.
SELINUX=Permissive
# SELINUXTYPE= can take one of these two values:
#     targeted - Targeted processes are protected,
#     mls - Multi Level Security protection.
SELINUXTYPE=targeted

Network connection is required in the following procedure.  
Edit /etc/sysconfig/network-scripts/ ifcfg-eth0 to be ONBOOT=yes.

...

For multilingual, web page for each language have to be prepared by the following procedure.
1. As same as showing the WEKO block, go to Setting Mode and show language and menu module.
2. In the language module, select the language which can to be selected in your page. 
3. After selecting an language, create a new page under the public space by using the menu module.
4. In the page created in 2, show WEKO block.
5. Same procedure have to be repeated for other language. 
 

# This file controls the state of SELinux on the system.# SELINUX= can take one of these three values:#     enforcing - SELinux security policy is enforced.#     permissive - SELinux prints warnings instead of enforcing.#     disabled - No SELinux policy is loaded.SELINUX=Permissive# SELINUXTYPE= can take one of these two values:#     targeted - Targeted processes are protected,#     mls - Multi Level Security protection.SELINUXTYPE=targeted