uApprove Jet Pack 3.2.0 User Manual
| 目次 | ||
|---|---|---|
|
...
1. Introduction
This document explanins how to give your consent to the release of attributes to Service Provider (in short, SP) via uApprove Jet Pack (in short, uApproveJP) 3.2.0.
The user consent steps are as follows:
- Login to the IdP.
- Select the optional attributes to be released to Service and confirm it.
- The attributes are released to the Service.
2. Operation flow
2.1 Login to the IdP
When using SP, redirect from SP to IdP of your organization, and log in to IdP.
...
If you want to reset attribute release approvals, you have to check the checkbox "Clear my attribute release consent". See 3. Reset-approvals for details.
2.2 Optional attribute selection
This page shows information about you that will be released to the SP(figure 2).
...
- This time I agree to send this data. I will check the data again at next login.
You can confirm the information that will be released to this SP, on every login session. - I agree that the data same as this time will be sent automatically to this service in the future. (default)
Allow to send the selected information when you use this SP again, automatically.
If next time you use this SP, this page will not display again unless the attributes on the agreed have been changed. See 2.2.1 Review the attributes change for if the attributes to have agreed changed. - I fully agree that in the future all my data will be released to the service provider as required by the service that I will access.
Allow to send all attributes to any SP automatically. If you choose this, all the optional attributes will be checked and can not be unchecked.
This page will never displayed again, even if the attributes on the agreed are changed or new attributes are added.
...
If you clicked the "Reject" button, your web browser will display messages indicating that the service is not available.
2.2.1 Review the attributes change
When any of the following conditions is satisfied on the SP where "I agree that the data same as this time will be sent automatically to this service in the future." option is applied, auto attributes sending is stopped and this review page (figure 2) is displayed.
...
To cancel your previous agreed information, go to reset your agreement at the login window.
2.3 Release of information
Mandatory attributes and selected optional attributes are sent to the SP.
...
| ギャラリー | ||||||
|---|---|---|---|---|---|---|
|
3. Reset-approvals
When you logged in with checking "Clear my attribute release consent" on login page, the information below is resetted and optional attribute selection(figure 2) will be displayed.
- Approval by selecting "I agree that the data same as this time will be sent automatically to this service in the future."
- Approval by selecting "I fully agree that in the future all my data will be released to the service provider as required by the service that I will access."
4. Difference from uApproveJP 2.5
The following points are different between uApproveJP 3.2 and uApproveJP 2.5.
...